Relay Module 5V Single Channel with Optocoupler
1) Channel: 1 channel.
2) Relay Voltage: 5V.
3) High impedance controller pin.
4) Pull-down circuit for the avoidance of malfunction.
5) Triode drive, increasing relay coil.
Share this product:
This is a 1 Channel 5V Relay Board Module For Arduino PIC AVR DSP ARM. A wide range of microcontrollers such as Arduino, AVR, PIC, ARM, and so on can control it. Each one needs a 15mA - 20mA driver current and is Equipped with a high current relay: DC 5V / 10A, AC 250V / 10A Standard interface that can be compatible with microcontrollers.
1 channel relay board
Operating Voltage 5V
Max Current : 20mA
Relay Contact Current Capacity at AC250V: 10A
Relay Contact Current Capacity at DC5V: 10A
One normally closed contact and one normally open contact
Triode drive, increasing relay coil
High impedance controller pin
Pull-down circuit for the avoidance of malfunction
Power supply indicator lamp
Control indicator lamp
Indicator for Relay output status
Can Be controlled various appliances & other Equipment With Large current.
Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)
The module is compliant with international safety standards, control and load areas isolation trenches
1 x 1 Channel 5V Relay Module with Optocoupler