L298P Motor Driver Shield for Arduino
1) L298P based Arduino motor driver shield
2) Onboard Buzzer (D4).
3) Onboard Bluetooth interface, you can directly plug, no wiring required.
4) Six Analog interfaces.
5) Forward, Backward steering indicators
Share this product:
The L298P Motor Driver Shield for Arduino is probably one of the most versatile on the market and features an onboard male header for an ultrasonic sensor connected to digital pins D7 & D8, female header for the Bluetooth module, servo header connected to pin D9, male headers connected to PWM pins D3, D5, D6. That makes it a great shield for any robotic project.
This Arduino compatible motor Driver shield is a full-featured product that can be used to drive 2 DC motors one 4-wire stepper and one 5v servo. It drives the DC motor and stepper with the L298P, the shield drives motors with digital pins D10, D11, D12, D13, and servo with digital pin D9.
We have a variety of modules that can be interfaced with this L293D Motor Driver/Servo Shield. Some of them are listed below click on their name to know more
The board with L298P motor drive chip, directly with the motherboard digital I/O port (D10, D11, D12, D13), without cumbersome wiring.
Onboard buzzer (D4), you can set the reverse alarm ringtones.
A convenient motor interface can be divided into two motor outputs.
Two-way Bluetooth interface, you can directly plug, no wiring.
D2, D3, D5, D6, D7, D9 are not occupied by the digital interface.
A 0 – A 5 six analog interfaces.
Forward and Backward steering are indicators.
1 x L298P Motor Driver/Servo Shield for Arduino
|Technical Specification ||Values|
|Logic Part Input Voltage||5VDC|
|Drive Part of the Input Voltage||6.5 ~ 12VDC|
|Drive Part of the Operating Current||2A|
|Maximum Dissipation Power||25W|