Mega 2560 R3 Development Board + RAMPS 1.4 Controller Control for Arduino Atmega2560 REV3+4PCS A4988 Drive

SKU: 2555

₹ 2,499.00 2499.0 INR ₹ 2,499.00

₹ 2,117.80

    This combination does not exist.

    Add to Cart Buy Now

    100% Original
    Free Delivery*
    Easy Return

    Share this product:

    product description/specificatiopns



    The A4988 stepper motor driver carrier is a breakout board for Allegro’s A4988 micro stepping bipolar stepper motor driver. The driver features adjustable current limiting, overcurrent and overtemperature protection, and five different micro step resolutions (down to 1/16-step). It operates from 8 – 35 V and can deliver up to approximately 1 A per phase without a heat sink or forced air flow (it is rated for 2 A per coil with sufficient additional cooling). 


    The RAMPS (RepRap Arduino Mega Shield) is an all-in-one design to fit the necessary components for a 3D printer into one plug in shield for an Arduino MEGA. The plugin shield design includes plug in stepper drivers and extruder control electronics sockets for easy service, part replacement, upgrade-ability, and expansion. Additionally, a number of Adruino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack. Ramps boards are the heart of most DIY 3D printers on the market and a nice clean compact way to integrate all the systems into a compact enclosure mountable format. 


    • RAMPS 1.4 3D Printer Controller Board

    • Arduino Mega 2560 Board, MCU: ATmega2560

    • Supply Voltage: 12V; Support 5 stepper drive board

    • 3 MOSFET’s are applied to the heater/ fan and thermistor circuit

    • 4PCS A4988 Driver With Heatsink


    • 1 X  RAMPS 1.4 Board kit (RAMPS + Power connector + Jumpers) 

    • 1 X  MEGA 2560 R3 CH340G Board 

    • 4 X  A4988 Drivers with heatsinks 

    • 1 X  Arduino Uno USB Cable

    Recently viewed Products