This Stepper Motor Controller Board is based on the TOSHIBA 2SC5200. This board can be used to generate PWM signals for the stepper motor driver, it has onboard buttons for the CW and CCW rotation of the stepper motor. The speed of the motor can be varied through the onboard potentiometer. When the board generates a frequency pulse signal, the high and low-frequency signal can be selected by the onboard jumper
It has three frequency ranges selectable via onboard jumpers.
Frequency can be measured via PUL and common cathode (GND) ports.
The board has two sets of power input
Operating Voltage (VDC): 12
Frequency Range: High: 5.8KHZ-127KHZ, Middle: 590HZ-15.8KHZ, Low: 82HZ-2.3KHZ
Dimension (mm): 73*51*37
Weight (gm): 44
1 X Stepper Motor Drive Simple Controller Speed Forward and Reverse Control Pulse Generation PWM Generation Controller