N20 3V 150RPM Micro Metal Gear DC Motor With Encoder
1) Encoder Test Wire Length: 140mm.
2) Wheel Dia.: 43 mm.
3) Rated Voltage: DC 3V.
4) Output Speed: 150RPM.
5) Milling Edge: 0.5 mm.
Share this product:
These N20 150RPM Micro Metal Gear 3V DC Motor With Encoder is intended for use at 3V. Though in general, these kinds of motors can run at voltages above and below this nominal voltage; so they should comfortably operate till the 3V (rotation can start at voltages as low as 0.5 V)
Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor. The micro metal gear motors are available in a wide range of gear ratios—from 5:1 up to 1000:1. With the exception of 1000:1 gear ratio versions, all of the micro metal gear motors have the same physical dimensions; so one version can be easily swapped for another if your design requirements change
This is a DC Mini Metal Gear Motor, ideal for making robots
Lightweight, high torque, and low RPM
Fine craftsmanship, durable, and not easy to wear
With excellent stall characteristics, can climb hills easily
You can also easily mount a wheel on the motor’s output shaft
1 x N20 3V 150RPM Micro Metal Gear DC Motor With Encoder